Double Shower Curtain Rod Installation Instructions

Once level have an assistant mark where the rod intersects the other wall.

Double shower curtain rod installation instructions.

Install your brackets using these marks for a level rod. Using the hardware that is incl. If there is a stud in your mounting location use wood screws to attach the wall brackets. Extend the adjustable curved shower rod as needed until it is the correct length then install the other end of the rod into the bracket on the opposite wall.

Once you find the proper height level the shower rod. Gently tap the anchors into the pilot holes with a hammer. Rotate the wall plate until it fits flush with the end of the rod. In this video we walk you through the steps in which you need to take to install your kenney double curtain rod in your home.

Lay the rod sections on the floor. Then move on to the next hole repeating the same process. There should be no gap between the base of the wall plate and the end of the rod. How to install spring loaded shower curtain rods.

It may use spring loaded clips that fit into holes in the bracket or screws that secure the rod to the bracket. Thread the shower curtain hooks rings through the curtain and liner. If not trim with a hacksaw. The method may vary by manufacturer.

Attach the rod and brackets to the wall with the mounting hardware provided. X pilot hole anchor. For rods 84 and longer assemble with the connector piece. Then install the rod and place a level across the length of the rod.

Hold it while you level the rod. Straight double shower curtain rod installation 5. Install the first bracket by screwing it into place. Drill pilot holes for the wall anchors.

Spring loaded or spring tension shower curtain rods are a quick solution to getting your shower splash under control or brushing up a less than. Starting from the left side thread one ring through the holes of both the curtain and the liner. Before installing installation curved double shower curtain rod pencil level tape measure screwdriver drill hammer hacksaw drill bit 1. Place the wall brackets onto the ends of the shower rod and tighten the set screws secure.

6 with the fronts of the 2 covers facing together slide the covers onto the rod see figure c.